Bosch AMAX 4000 - Address Programming; Communication and Report Programming; Receiver Programming

Address Programming
The control panel programming options are stored in a non-volatile flash memory. This
memory has all relevant configuration and user-specific data even after a total power loss.
Because the data retention time is quite long without power, reprogramming is not required
after powering up the control panel.
Programming with keypad is possible only when all of zones in the system are in disarmed
status and no alarm is activated. The installer code is required for programming.
Notice!
It is not recommended to use other keypads or methods simultaneously to program the
system while programming with the current keypad.
The following chapters show an overview of all relevant programming options and their
addresses according to the descriptions in the chapter Settings, page 32.
Communication and Report Programming
Receiver Programming
Receiver No. Option Address Default
1 Transmission format for receiver (0 = not
used, 1 = CID, 2= SIA, 3 = Conettix IP, 4 = SIA
DC 09, 5 = SIA DC09 (2x ID))
0023 1
Telephone number / IP address and port 0000 – 0016 15
Subscriber ID number (0 – 9, B – F) 0017 – 0022 000000
Anti-replay for receiver (0 = disabled, 1 =
enabled)
0024 1
EN=1
Acknowledge wait time for receiver (05 - 99
seconds )
0025 – 0026 05
Network polling time for receiver (001 - 999
minutes )
0027 – 0029 001
DC09 data format (1 = ADM-CID, 2 = SIA-
DCS)
0140 1
DC09 acct1 length (3 – 16, all other input is
treated as “3”)
0141 – 0142 06
DC09 acct1 (0 - 9 = 0 - 9, 10=A, 11=B, 12=C,
13=D, 14=E, 15=F)
0143 – 0158 000001
000000
0000
DC09 acct2 length length (3 – 16, all other
input is treated as “3”)
0159 – 0160 06
9
9.1
9.1.1
AMAX 2100 / 3000 / 4000 Address Programming | en 105
Bosch Sicherheitsysteme GmbH Installation Guide 2014.11 | 02 | F.01U.267.112