Bosch C 80 - Page 126

144 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

18 | Firmware

126/144 Manual_C_80 Bosch Motorsport

When the firmware update is complete, the C 80 displays the message ‘Updating

firmware finished. Do a powercycle.’ Switch the car’s ignition off and on again to cycle

the power of the C 80.

Table of Contents

Default Chapter2
- Table of Contents2
1 Preparation4
2 Warnings and Safety Instructions5
3 Onboard Network Concept6
4 Technical Data7
5 Mechanical Drawing11
6 Communication Channels12
7 System Configuration Tool Racecon13
8 First Steps14
- Connecting the Unit to Racecon14
- Setting up a New Racecon Project15
- Feature Activation19
- First Recording (Quick Start)21
- Set Date and Time24
- Color Indication26
- Assign the Mounting Location27
9 Project Configuration31
- Math Channels31
- Conditional Functions32
- Conditional Channels34
- Condition Combination36
- Display Switch Module38
- Timer Module39
- GPS Trigger Module39
- CPU Load Limits41
10 CAN Configuration42
- CAN Bus Trivia42
- CAN Input43
- CAN Output49
- Multiplexer51
11 Export and Import in Racecon54
- Export in Racecon54
- Import in Racecon54
12 Analog and Frequency Inputs56
- Analog Inputs56
- Configuring Inputs57
- Configuring Computed Sources70
- Hysteresis71
13 Online Measurement and Calibration75
- Setting up an Online Measurement75
- Online Calibration of Measurement Channels80
- Online Calibration of Multipoint Adjustment Channels82
14 Recording84
- Features84
- Configuration of Recordings84
- Event Logging88
- USB Recording89
15 Telemetry System LTE 6594
- Software Setup94
- Telemetry Channels with Special Functionality95
- Setting up Car in Wdserver96
- Loading the Telemetry Data100
16 Error Memory101
- Error Memory Representation in Racecon101
- Information on Errors Available from the Error Memory103
- Analog Input Diagnosis107
17 Lap Trigger109
- Lap Trigger (Timing Beacon)109
- Counting Outing/Laps/Fragments115
- Lap Timing116
- Segment Timing118
- Countdown Timer120
- Automatic GPS Track Detection121
- Predated Laptime122
18 Firmware124
- Firmware and Configuration124
- Firmware Update124
19 Cloning the Unit127
20 GPS Sensor129
- GPS (Global Positioning System)129
- Protocol129
- Sensor Recommendation130
- Measurement Labels132
- GPS Troubleshooting133
21 Fuel Consumption Calculation135
- Setting up Fuel Consumption Calculation and Tank Management135
- Fuel Consumption Diagnosis/Counter Reset136
22 Racecon Shortcuts138
23 REACH Statement139
24 Disposal140

Related product manuals

Preview: Bosch C 60

Preview: Bosch C 70

Bosch Rexroth ID 40/SLK-CAN

Preview: Bosch Rexroth ID 40

Bosch Rexroth ID 40