Boss BR-600 - Tremolo;Pan; Voice Transformer

109
Insert Effect Parameter Functions
Rev0.10
Section 3
Tremolo is an effect that creates a cyclic change in volume.
Pan cyclically moves the stereo position between left and
right (when stereo output is used).
* This effect can be used when the MODULATION “Type”
parameter is set to “TRM/PAN.”
On/Off OFF, ON
This parameter turns the tremolo/pan effect on/off.
Mode
Selects tremolo or pan; also selects how the effect is applied
TRM-TRI :
The volume will change cyclically. Smooth change will be
produced.
TRM-SQR :
The volume will change cyclically. Abrupt change will be
produced.
PAN-TRI :
The sound will be moved cyclically between left and right.
Smooth change will be produced.
PAN-SQR :
The sound will be moved cyclically between left and right.
Abrupt change will be produced.
* “PAN-TRI” and “PAN-SQR” are obtained with stereo
recording (using two tracks).
Rate 0 – 100
Adjust the rate at which the effect will operate.
Depth 0 – 100
Adjusts the depth of the effect.
This controls the formants, allowing a variety of voice
characters to be created.
This adds two voice characters with differing formants to
the direct sound.
On/Off OFF, ON
This parameter turns the voice transformer effect on/off.
Formant1 -100 – +100
Adjust the formant of the voice character 1.
Formant2 -100 – +100
Adjust the formant of the voice character 2.
FX1 Level 0 – 100
Adjust the volume of the voice character 1.
FX2 Level 0 – 100
Adjust the volume of the voice character 2.
Dir Level 0 – 100
Adjust the volume of the direct sound.
Tremolo/Pan Voice Transformer