33
Quick Start
Moving the current position
You can use the following method to move the current
position.
The song fast forwards as long as the [FF] is held down, and
rewinds (reverses) while the [REW] button is held down.
To move to the time where the first sound of a song is
recorded, press and hold [STOP] and press [REW].
Each V-Track of the selected track is checked and you move
to the time of the first recorded sound for the song.
Press [ZERO] to move to the time location 00:00:00-00.0.
To move to the time where the last sound of a song is
recorded, press and hold [STOP] and press [FF].
Each V-Track of the selected track is checked and you move
to the time of the last recorded sound for the song.
fig.00-210
Press [ ] [ ] to move the cursor to hours, minutes,
seconds, frames, or sub-frames display, and turn the TIME/
VALUE dial to change the current time in the song.
The current position in the song is indicated at the left of the
upper row as "measure-beat-clock."
* For the demo songs, an Arrangement (p. 134) has already
been created and it is set so that measure, beat, clock, and
song is properly synchronized.
Press [ ] [ ] to move the cursor to “measure” or “beat”
display, and turn the TIME/VALUE dial to change the
current measure or beat in the song.
* You cannot move the cursor to Clock (cannot be altered).
■ Fast Forwarding and
Rewinding
■ Moving to the start of a
play
■ Moving to the end of a play
■
Moving through a song using
hours, minutes, seconds,
frames, or sub frames
TIME
23:59:59-29.900:00:00-00.0
[
ZERO
]
[
STOP
] + [
REW
]
[
STOP
] + [
FF
]
Section of the song recorded
■ Moving through a song in
measures or beats
BEAT
MEASURE CLOCK
TIME
Elapsed time display
The current time shown in the lower row of the display
is in MTC (MIDI time codes), indicated as
" hours-minutes-seconds-frames-sub frames."
To Next Page
Loading...
