Boss BR-600 - Page 76

76
Editing the Performance on a Track (Track Edit)
Rev0.10
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.02-180
3
Press CURSOR [ ] [ ] to move the cursor to
“CPY,” and press [ENTER].
fig.02-190
4
Turn the TIME/VALUE dial to select “TME/MES”
and press [ENTER].
fig.02-200
5
Use CURSOR [ ] [ ] and the TIME/VALUE dial
to select the track/V-Track to copy from, and track/V-
Track to copy to.
6
Press [ENTER].
fig.02-210
7
Use [CURSOR] and the TIME/VALUE dial to specify
the beginning of the portion “S” (Start) of data you
want to copy.
8
Press [ENTER].
fig.02-220
9
Use [CURSOR] and the TIME/VALUE dial to specify the
ending of the portion “E” (End) of data you want to copy.
10
Press [ENTER].
fig.02-230
11
Use [CURSOR] and the TIME/VALUE dial to specify
the time of the beginning of the location “T” (To)
where you want the copied data to be placed.
12
Press [ENTER].
fig.02-240
13
Turn the TIME/VALUE dial to select the number of
copies you want to be placed.
14
When you are ready to execute the copy, press [ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
15
Press [ENTER].
The copy is executed.
16
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
Copy Source
Copy Destination