Brocade Communications Systems DCX 8510-8 User Manual

Removal and Replacement Procedures
• Introduction.......................................................................................................................................................................................................... 99
• ESD precautions................................................................................................................................................................................................ 99
• Chassis door removal and replacement...................................................................................................................................................99
• Cable management comb removal and replacement.....................................................................................................................101
• Port and application blade removal and replacement.....................................................................................................................102
• Blade ller panel removal and replacement.........................................................................................................................................105
• Control processor blade (CP8) removal and replacement............................................................................................................ 107
• Core switch blade (CR16-x) removal and replacement..................................................................................................................119
• Power supply removal and replacement...............................................................................................................................................121
• Blower assembly removal and replacement....................................................................................................................................... 124
• WWN card removal and replacement....................................................................................................................................................126
• Transceiver and ber optic cable removal and replacement.........................................................................................................134
• Chassis removal and replacement...........................................................................................................................................................140
Introduction
NOTE
Read the safety notices before servicing (Caution and Danger Notices on page 187).
The eld-replaceable units (FRUs) in the device can be removed and replaced without special tools. The device can continue operating
during many of the FRU replacements if the conditions specied in the procedures are followed.
The following sections contain FRU removal and replacement procedures (RRPs).
ESD precautions
The device contains ESD-sensitive FRUs. When working with any device FRU, use correct electrostatic discharge (ESD) procedures.
• Wear a wrist grounding strap connected to chassis ground (if the device is plugged in) or a bench ground.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
• Store all ESD-sensitive components in antistatic packaging.
CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep static-sensitive
devices in their static-protective packages until you are ready to install them.
Chassis door removal and replacement
NOTE
The chassis door must be installed to ensure that the device meets EMI and other regulatory
certications.
Brocade DCX 8510-8 Backbone Hardware Installation Guide
53-1002180-15 99

Brocade Communications Systems DCX 8510-8 Specifications

General

Brand	Brocade Communications Systems
Model	DCX 8510-8
Category	Switch
Language	English