EasyManua.ls Logo

Brookfield DV3T - VI.3 Viscosity Test Program Controls

Brookfield DV3T
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Brookeld Engineering Labs., Inc. Page 77 Manual No. M13-167-A0415
TheGeneral ParameterssectionincludesallViscosityTestprogramcontrolsthatwillapplyto
everystepoftheprogram.
Spindle: The spindle to be used with this Viscosity
Test.All calculations will be based on this
spindlenumber.
ReportScreen: Select the view to be presented upon the
conclusionoftheViscosityTest.
SaveResultsPath: Selectifapathforsavingdataistobedened.
Denethesavepath.
PostTestAveraging: Selectthetypeofaveragingtoperformatthe
endofthetest.
Instructions: Document the instructions to present to the
operatorwhenthetestisrun.
TheTest ParameterssectionincludesallViscosityTestprogramcontrolsthatmayvaryifthere
ismorethanoneteststep.
Speed: Speedofrotationofthespindle.
DataCollection: DataCollectionmethod.
TimeInterval: TimeintervalusedforDataCollectionmethods
thatincludeaveraging.
Density: Densityvaluetobeusedifkinematicviscosity
unitsareselected(cSt,mm2/s).
EndCondition: ConditionwhichsetstheendoftheViscosity
Test.
EndConditionValue: ParameterbasedonchosenEndCondition.
QCLimits: ParametertobeusedforQClimitindicators.
QCHigh/QCLowLimit ParameterbasedonthechosenQCLimits.
CollectSinglePointatStepEnd: DuringaMultiPointdatacollection,forcethe
DV2Ttocollectadatapointattheendofthe
step(whentheEndConditionisachieved).
IncludeThisStepintoAverageCalculation: Data from this step will be included in the
averagecalculationindicatedbytheselection
inPostTestAveraging.
Add,Insert,DeleteStepButtons
SaveButton
TheProgram GridshowsallTestParametersforeachstepinalineview.
AllmeasurementunitscanbesetthroughtheUnitsSetupbutton(seeFigureVI-2).Thismenu
canbepinnedtothescreen.Ifthemenuisnotpinned,thenitwillminimizewhenthemouseis
movedoutsideofthewindow.

Table of Contents

Related product manuals