Brother 2104D - Over Looper Position Adjustment

3 - 10
Adjustment
Adjustment Adjustment
Over looper position adjustment
1. Turn the pulley counterclockwise rotation, and
then the over looper is the most left position.
2. Loosen the adjusting screw (screw, bind M4x4).
3. Set the gauge at the position of the figure.
4. Move the over looper, and then adjust the tip of
the over looper to the position of contacting with
the gauge.
5. Fasten the adjusting screw (screw, bind M4x4).
Over looper
Pulley
Screw, bind M4x4
Gauge
6.4 mm
Needle (left)
Over looper
Screw, bind M4x4