4 - 4
1.Starting in test mode
With the front cover in place press and while turning the power on; the buzzer
will sound four times, and test mode will start.
2. Mode selection
<S2>
Press , and select pattern number (mode).
<S3>
Select the pattern number (mode) using or , and press .
3. Starting and stopping test mode
Press
4. Returning to the test mode selection screen
When test mode is stopped, press
5. Test modes (used for adjustments)
Mode
Mode selection
Screen number
Z (zigzag)
operations
F (feed)
operations
Operating speed
3 point needle
drop
S2
Switches left base line / center
base line / right base line with
each stitch
*Pressing stops the base
line from changing.s
0 mm
(none)
Any speed may be
selected using the
speed control key
S3
Feed
adjustment
S2
100 stitches forward on the left base line
100 stitches reverse on the right baseline
Switches low / middle /
high speed with each
push of .
S3
Slowly
Test mode selection screen (S3 only)
Test Mode
www.promelectroavtomat.ru
To Next Page
Loading...
Need help?
General
