Brother HL-L3210CW - Page 35

2-16
Confidential
Error
Codes
Description
Refer
to:
Error
Codes
Description
Refer
to:
6001
The top cover sensor detected that
the top cover was open.
2-60 6300
The electrodes of the high-voltage
power supply PCB detected that no
waste toner box was set.
2-64
6002 *1 6400
The registration mark sensor detected
that no belt unit was set.
2-64
6003 *1
6602 *1
6701 *1
6004
The eject sensor detected that the
fuser cover was open.
2-61 6801
The internal temperature sensor
detected a temperature higher than
the specified value.
2-64
6007 *1 6802 *1
6101
Developing terminal voltage detected that
the toner cartridge (black) was not installed.
2-61 6901
Some fuser unit errors occurred at power-
ON or upon recovery from sleep mode.
2-65
6102
Developing terminal voltage detected
that the toner cartridge (yellow) was
not installed.
2-61 6902
After the error was detected at the
fuser unit, power was turned ON
again and the error is being checked.
(If power is turned OFF and ON after
error code 6901 occurred, this code is
displayed for about 15 minutes.)
2-65
6103
Developing terminal voltage detected
that the toner cartridge (magenta) was
not installed.
2-61 6A00
Electric discharge that may be caused
by dirt on the corona wire of the drum
unit was detected.
2-66
6104
Developing terminal voltage detected
that the toner cartridge (cyan) was not
installed.
2-61 6B01
Electric discharge was detected when
the number of the black drum unit
rotations had become more than twice
of the upper limit.
2-66
6106 *1 6B02
Electric discharge was detected when
the number of the yellow drum unit
rotations had become more than twice
of the upper limit.
2-66
6200 *1 6B03
Electric discharge was detected when
the number of the magenta drum unit
rotations had become more than twice
of the upper limit.
2-66
6201
GRID terminal signal detected that the
black drum unit was not installed.
2-62 6B04
Electric discharge was detected when the
number of the cyan drum unit rotations had
become more than twice of the upper limit.
2-66
6202
GRID terminal signal detected that the
yellow drum unit was not installed.
2-62
6B0A *1
6203
GRID terminal signal detected that the
magenta drum unit was not installed.
2-62 6C01 *1
6204
GRID terminal signal detected that the
cyan drum unit was not installed.
2-62 6C02 *1
6208 *1 6C03 *1
6209 *1 6C04 *1
620A
Electrified terminal or GRID terminal signal
detected that the black drum was not
installed when the machine was turned ON.
2-62 6D00 *1
620B
Electrified terminal or GRID terminal signal
detected that the yellow drum was not
installed when the machine was turned ON.
2-62 6E00
The develop release sensor detected
the develop roller disengagement or
engagement failure.
2-66
620C
Electrified terminal or GRID terminal signal
detected that the magenta drum was not
installed when the machine was turned ON.
2-62 6F00
Detected that supply power is
unstable (less than 100 times).
2-67
620D
Electrified terminal or GRID terminal signal
detected that the cyan drum was not installed
when the machine was turned ON.
2-62 7000
After the registration rear sensor
detects paper pass, the eject sensor
does not detect paper pass.
2-67