2-72
Confidential
■ Error code 8D02
The paper size indicated for printing data while the back cover is closed was under the
specified value.
<User Check>
• Length of the paper is 114 mm or more.
■ Error code 9002
The size of paper loaded in the T1 and the one specified from the driver are not same when
printing from the T1.
<User Check>
• Change the driver setting to be matched with the size of the paper set in the T1.
■ Error code 9202
When printing from the T1, paper type setting in the machine does not match the setting in the
driver.
<User Check>
• Use the same paper type setting for the machine and driver.
Step Cause Remedy
1
Registration rear actuator caught
in some sections of the machine
Reattach the registration rear actuator.
2 Registration rear sensor failure Replace the paper feed unit.
3 Main PCB failure Replace the main PCB.
Step Cause Remedy
1
Registration rear actuator caught
in some sections of the machine
Reattach the registration rear actuator.
2 Registration rear sensor failure Replace the paper feed unit.
3 Main PCB failure Replace the main PCB.
Step Cause Remedy
1 Malfunction of the main PCB Install the latest main firmware.
2 Main PCB failure Replace the main PCB.
To Next Page
Loading...
