4-37
Confidential
(19) Disconnect the connector of the Scanner motor harness from the Driver PCB.
(20) Disconnect the connectors of the Home position sensor harness and FFC cable from the
Main PCB.
Fig. 4-57
(21) Disconnect the six connectors of the each harness from the Main PCB.
Fig. 4-58
Note :
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
Driver PCB
Driver PCB
Scanner motor harness
FFC
Home position sensor harness
Main PCB
Main PCB
Driver PCB
Driver harness
NCU harness
Panel PCB harness
USB HOST
harness ASSY
Main PCB
Speaker harness
Battery harness
To Next Page
Loading...
