6-12
Confidential
6.1.3 ADF & Document Cover ASSY
(1) Place the scanner cover upside down.
(2) Insert the tip of a flat screwdriver into the slit provided in the harness support and twist it to
release the two latches and then take the harness support out of the scanner cover.
Assembling Note: Before fitting the harness support (shown above) into the scanner
cover, route the document sensor PCB harnesses and the bundle of ADF motor harness and
its grounding wire through the guide curve provided in the harness support. The CIS motor
harness and the grounding wire should be placed at the rightmost position (viewed from the
bottom) in the square opening in the scanner cover.
Harness suppor
Flat screwdriver
(6_10_BHL9_A4)
Scanner cover
(placed upside down)
Grounding wire
CIS motor harness
Harness support
Latches
Bundle of harnesses
(Document sensor PCB harness,
ADF motor harness,
and grounding wire)
Guide curve
To Next Page
Loading...
