6-86
Confidential
6.2 LUBRICATION
Apply the specified lubricants to the lubrication points as shown below.
Head/carriage unit
Apply a 1.5 mm diameter ball of grease (Permalub BAN-5) to the lubrication points below.
Lubricant type
(Manufacturer)
Lubrication points
Lubricant amount
per point
Permalub BAN-5
(Nippon Koyu)
Head/carriage unit 1 1.5 mm diameter ball
Motor plate and CR guide rail
(bottom edges)
4 1 mm diameter ball
Switching lever guide 1 3 mm diameter ball
FLOIL BG1319
(Kanto Kasei)
CR guide rail (upper face) 8 2 mm diameter ball
CR support chassis (upper
face)
8
CR support chassis (front and
rear sides of upright rear
edge)
22
Molykote EM-30LP
(Dow Corning)
Paper pull-in roller L 2 1 mm diameter ball
(6_90)
Apply grease here.
Head/carriage unit
To Next Page
Loading...
