Brother MFC5490CN - Wsw04

App. 4-7
Confidential
• Selectors 6 and 7: Dial tone detection in PBX (Not used.)
These selectors activate or deactivate the dial tone detection function which detects a dial
tone when a line is connected to the PBX.
Setting both of these selectors to "1" activates the dial tone detection function so that the
machine starts dialing upon detection of a dial tone when a line is connected.
Other setting combinations deactivate the dial tone detection function so that the machine
starts dialing after the specified WAIT (3.5, 5.0, or 7.0 seconds) without detection of a dial
tone when a line is connected.
WSW04 (TRANSFER facility setting)
ms: millisecond(s)
Note: Selectors 6 through 8 are not applicable in those countries where no transfer facility is
supported.
Note: Selectors 2 through 4 are applicable to models with built-in TAD.
• Selector 1: Earth function in transfer facility (Not used.)
This selector determines whether or not the earth function is added to the transfer setting
menu to be accessed by the function switch.
Selector
No.
Function Setting and Specifications
1
Earth function in transfer facility
(Not used.)
0: Provided 1: Not provided
2
3
Dual tone detection frequency in
ICM recording
(Not used.)
No. 2 3
0 0 : 350 and 440 Hz (A)
0 1 : 440 and 480 Hz (B)
1 0 : 480 and 620 Hz (C)
1 1 : 480 and 620 Hz (C)
4
Dual tone detection sensitivity in
ICM recording
(Not used.)
0: Normal 1: High
5
Time to be added to the setting
specified by selectors 3 and 4 of
WSW24 (Time length from CML
ON to start of pseudo ring
backtone transmission)
0: Not added 1: +4 seconds added
6
|
8
Break time length for flash
function
No.678
000: 80 ms
001: 100 ms
010: 110 ms
011: 120 ms
100: 200 ms
101: 250 ms
110: 500 ms
111: 700 ms