6-18
Confidential
Lower ADF chute
(11) Cut off the cable tie that binds a bundle of harnesses (ADF motor harness and its grounding
wire, and document sensor PCB harness) to the document cover.
(12)Remove the two screws from the lower ADF chute, and take the lower ADF chute off the
document cover.
Assembling Notes:
• When mounting the lower ADF chute on the document cover, insert the two tabs
provided on the left side of the lower ADF chute into the square holes in the document
cover.
• After mounting the lower ADF chute, be sure to route a bundle of harnesses (ADF motor
harness and its grounding wire, and document sensor PCB harness) on the underside of
the document cover and secure the bundle with a cable tie as shown below. After binding,
cut off the excess of the cable tie with nippers.
Document cover
Cable tie
Grounding wire
ADF motor harness
Document cover
Lower ADF chute
Document sensor PCB harness
6
16
Taptite, cup B
M3x10
Bundle of harnesses
(ADF motor harness, grounding wire,
and document sensor PCB harness)
Tab
Tab
Square hole
Square
hole
(Left)
(6_25)
Document cover
Cable tie
Cut off the excess of the
cable tie with nippers.
Bundle of harnesses
(ADF motor harness, grounding wire,
and document sensor PCB harness)
To Next Page
Loading...
