Brother MFC5490CN - 10 ] Replace the Ink Cartridges with the Protective Part; 9 ] Switch Back to Standby

7-27
Confidential
[ 9 ] Switch back to standby
After completion of the adjustment, disconnect the USB cable.
Then press the 9 key twice to return to the standby state.
Note: Be sure to disconnect the USB cable first. Returning to standby without disconnecting the
USB cable runs "Found New Hardware Wizard" that starts USB driver installation (as
described in Section 7.1.2).
Note: Enable the initial setup mode (Function code 63). (See Chapter 9, Section 9.4.17)
[ 10 ] Replace the ink cartridges with the protective part
Remove all four ink cartridges and set the protective part instead. Check that the small tabs on
both sides of the protective part fit in the holes inside the ink refill ASSY.
1
1
Protective part
(Protective_part_L9A4)