9-22
Confidential
9.4.11 Setting of Country/Language (Function code 52) (User-accessible)
Function
Machines have been customized for their destination countries with the corresponding
EEPROM customizing codes (see Section 9.4.22, Function code 74). However, some
customizing codes are shared by two or more destination countries, so the machines customized
by these codes require further specifying individual destination countries or languages.
Usually, the user specifies the destination country or language on the LCD screen called up
automatically when turning the machine on first after purchase. In the same way, the service
personnel also specifies it if the main PCB is replaced; however, if he/she skips the
specification process at that timing, be sure to perform the procedure given below.
Operating Procedure
(1) Press the 5 and 2 keys in this order in the initial stage of the maintenance mode.
The "Set Country" appears on the LCD.
NOTE: If an EEPROM customizing code other than those listed above has been specified,
the machine automatically returns to the initial stage of the maintenance mode without
displaying the country/language menu.
NOTE: The messages shown during this procedure are in US English.
(2) Use the and keys to display the desired country or language.
NOTE: For selectable countries, refer to the table shown above.
(3) Press the OK key, and the machine saves the new setting and returns to the initial stage of
the maintenance mode. This completes the setting procedure.
EEPROM Customizing Code Countries
0057 Norway, Sweden, Finland, and Denmark
0056 Australia and New Zealand
To Next Page
Loading...
