Brother MFC5490CN - Caller ID Tone Alert Detection Period; Pictbridge Command Delay Time; Recovery of Cordless Handset ID

App. 4-57
Confidential
WSW54 (Function setting 19)
ms: millisecond(s)
Note: Selectors 1 and 2 are applicable to PictBridge-enabled models.
Note: Selector 4 is applicable to models with cordless handset.
Note: Selectors 5 through 7 are applicable to the UK models.
Note: Selector 8 is applicable to the Chinese models.
• Selectors 1 and 2: PictBridge command delay time
These selectors specify the PictBridge command delay time that applies when the machine
responds to the digital camera connected via PictBridge during negotiation. If the machine
fails to receive data from the digital camera, change the delay time.
• Selector 3: Extension of the "No. of CNG cycles to be detected" for Easy Receive mode
In Easy Receive mode, if the machine fails to detect the CNG even after the setting made
by selectors 4 and 5 on WSW26, extend the "No. of CNG cycles to be detected" by two
cycles.
• Selector 4: Recovery of cordless handset ID (Not used.)
Enabling this function automatically writes the cordless handset ID registered on the main
PCB onto the cordless PCB when the power is turned on if the ID on the cordless PCB is
discrepant with the one on the main PCB.
• Selectors 5 and 6: Caller ID tone alert detection period
If the machine misdetects a tone alert for a caller ID, adjust the detection period with these
selectors.
Selector
No.
Function Setting and Specifications
1
2
PictBridge command delay time
No. 1 2
0 0 : 100 ms (default)
01: 0 ms
10: 50 ms
11: 200 ms
3
Extension of the "No. of CNG
cycles to be detected" for Easy
Receive mode
0: No 1: + 2 cycles
4
Recovery of cordless handset ID
(Not used.)
0: Enable 1: Disable
5
6
Caller ID tone alert detection
period
No. 5 6
0 0 : 10 ms (default)
01: 20 ms
10: 30 ms
11: 40 ms
7
Transmission of caller ID wetting
pulse
0: Enable 1: Disable
(default)
8
Switching between DTMF and
FSK for caller ID
0: DTMF 1: FSK
(default)