Brother PR655 - Panel Rear Cover Removal

2 - 80
Operation panel
Main unit
Disassembly Disassembly
6 Panel rear cover removal
1. Remove the 4 screws 1.
2. Remove the panel rear cover 1, and then disconnect the connector 2.
1
1
1
1
2
7 Lead wire assy panel removal
1. Remove the screw 1, and then remove the ground wire 1 of the lead wire
assy panel 2 and the ground spring 3 from the panel rear cover.
2. Push the lock part 4 of the cord bushing 5, and then pull out the lead wire
assy panel 2 from the panel rear cover.
3. Open the lock part 4, and then remove the cord bushing 5 from the lead
wire assy panel 2.
1
4
1
325
4
5
2