Brother PR655 - Power Switch Assembly and Inlet Removal

2 - 62
Power unit
Main unit
Disassembly Disassembly
1 Power switch assembly and inlet removal
1. Remove the screw 1, and then remove the cord clamp (NK-6N).
2. Remove the 2 screws 2 and remove the inlet cover lid, and then remove
the rocker switch on the power switch assembly from the inlet cover.
3. Remove the 2 screws 3, and then remove the inlet cover.
4. Remove the 2 screws 4, and then remove the power switch assembly.
5. Remove the 2 power lead wire assemblies 1 from the power switch
assembly.
1 2
4 3
1
2 EX connector holder removal
1. Remove the 2 screws 1, and then remove the EX connector holder 1.
2. Remove the 2 screws 2, and then remove the EX connector holder cover
2 from the EX connector holder 1.
2
1
2 1
3 Power supply unit removal
1. Remove the 3 screws 1, and then remove the power supply unit 1.
2. Disconnect the connector 2 of the power switch assy from the power
supply unit 1.
1
1
1 2