14
BRAVO Analyzer - User Manual
Safety 1
1.8 Electromagnetic compatibility (EMC)
EU regulations
The BRAVO analyzer has been developed according to EN 61326-1:2013 Electrical
equipment for measurement, control and laboratory use - EMC requirements - Part 1:
General requirements. The BRAVO analyzer is a class A equipment.
Class A equipment is suitable for the use in all establishments other than domestic and
those directly connected to a low voltage power supply network which supplies buildings
used for domestic purposes.
➣ Important note: In a domestic environment, BRAVO may cause radio interference.
In this case, the operator may be required to take corrective actions in order to stop
radio interference.
US / FCC regulation
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference when the equipment is operated in a
commercial environment.
➣ Important note: This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may
cause interference to radio communications. Operation of this equipment in a resi-
dential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user's authority to operate the equipment.
1.9 Intended use
BRAVO is a handheld spectrometer intended for Raman spectroscopic measurements
and subsequent qualitative evaluation for the purpose of raw material verification.
Due to the measurement technique, BRAVO is suited for analyzing all kinds of solid and
liquid samples which are Raman active, excluding highly flammable substances for
safety reasons.
BRAVO is intended for indoor usage under the ambient conditions specified in
appendix A.2.
The intended use includes also the compliance with the relevant standards and regula-
tions, especially:
• EN 60825-1 - Safety of laser products - Part 1: Equipment classification and
requirement
• national and local safety regulations
• national and local accident prevention regulations
• generally recognized technical regulations
The intended use also includes the strict observance of all instructions given in this man-
ual, namely:
• safety instructions
• operation and handling instructions
• cleaning instructions
To Next Page
Loading...