6
BRAVO Analyzer - User Manual
Safety 1
i
The symbol i will draw your attention to additional pieces of information which might be
useful for you.
1.3 Overview of possible types of hazard
1.3.1 Possible hazards during installation and operation
Hazards that can possibly occur during operating the analysis instrument BRAVO are
indicated by the appropriate warning symbols. The following warning symbols indicate
different dangerous situations which may be caused by an improper use of the analysis
system:
➣ Important note: All warning labels on the analysis system BRAVO must always be
kept legible. Immediately replace a worn or damaged label.
NOTICE
➣ Indicates a practice which could result in property damage if the given instructions
are not observed.
Warning
symbol
Definition
General hazard:
This warning symbol indicates general hazard. The label is located
near the danger spot in question. Observe the safety instructions and
follow the precautions described in the manual to avoid personal injury
and/or property damage.
Laser radiation:
This warning symbol indicates the existence of laser radiation. The
label is located near the opening at which hazardous laser radiation
exits the instrument. Do not look directly into the laser beam or use
any kind of optical instruments to look into the beam as this may cause
permanent eye damage.
Electrical shock:
This warning symbol indicates electrical hazard. It is located near live
parts or enclosures behind which are live parts that represent an acci-
dental contact hazard. Do not touch these parts. Before removing the
corresponding housing part and beginning any repair works, first turn
off the mains power switch and unplug the power cord. Prevent all live
parts from coming into contact with a conductive substance or liquid.
Non-observance of the relevant safety instructions can cause severe
injury and/or property damage.
To Next Page
Loading...
General