22
BRAVO Analyzer - User Manual Bruker Optik GmbH
BRAVO analyzer - Overview 3
3.2 Laser status LED
Front side
⑬ - Measuring tip (exchangeable)
⑭ - Barcode reader
Back side
⑮ - Battery compartment door
(removable)
Laser status LED is off.
➣ The laser is disabled (i.e. it is not ready
for emitting radiation).
Laser status LED lights continuously blue.
➣ Laser is enabled (i.e. it is ready for emit-
ting radiation) and laser safety status is
OK.
Laser status LED lights up red.
➣ Laser emits radiation.
Note: The red laser status LED is of a tempo-
rary nature only. As soon as the measurement
is finished, the laser status LED returns to blue
indicating that the laser radiation emission is
over.
Laser status LED is flashing blue.
➣ This indicates a laser safety problem. In
this case, you cannot start a measure-
ment. Contact the Bruker service.
☞ For service contact data, see section 1.6.
To Next Page
Loading...