14 – 4 Repair Manual RRE140/160/180/200/250 © BT
Hydraulic system 6000
Hydraulic unit (6100)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
14.1.3 Removing the pump motor from the
truck
1. Lower the forks to their lowest position to reduce pressure in the
hoses and pump.
2. Disconnect the battery connector.
3. Drain the hydraulic tank from oil, see “14.1.1 Hydraulic tank, drain-
ing” on page 14 – 2.
4. Remove the power cables from the pump motor.
5. Undo the temperature and speed gauge contacts on the motor.
6. Remove the pressure hose (b) from the pump (quick change con-
nector) and undo the suction hose (c) (hose clips) from the pump.
7. Fasten a lifting eye to the motor shaft
.
8. Remove the screws (a) (6 mm allen screws) that hold the pump
motor mounting to the chassis.
9. Lift out the hydraulic motor with the hydraulic pump and place it on
a clean surface.
Mom 7: M12×1,75
a
b
c
To Next Page
Loading...
