2002 Buell X1: Chassis 2-49
HOME
11WARNING1WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
18. Remove lifting straps and install seat. See
2.40 SEAT.
11WARNING1WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
19. Attach both battery cables, positive cable first.
20. Remove motorcycle from lift.
21. Compress suspension to install rear fender and lower
belt guard. See
2.32 REAR FENDER.
22. Check oil level after starting motorcycle and allowing it to
reach operating temperature.
11WARNING1WARNING
After completing repairs or bleeding the system, always
test motorcycle brakes at low speed. If brakes are not
operating properly or braking efficiency is poor, testing
at high speeds could result in death or serious injury.
23. Check rear brake operation.
To Next Page