Buell X1 2002 - Seat

2-82 2002 Buell X1: Chassis
HOME
SEAT 2.40
REMOVAL
NOTE
Depending upon vehicle production date, lock orientation
may vary from
Figure 2-135.
1. Place ignition key in seat lock and turn.
CAUTION
Do not place keys in underseat storage area. If seat is
installed, keys will not be accessible.
2. Lift seat and remove.
INSTALLATION
1. Install seat by sliding metal locating tab on underside of
seat into opening on motorcycle.
2. Press down on seat until seat catch clicks.
11WARNING1WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
3. Turn ignition key and remove from seat lock.
ATTACHMENT POINTS
CAUTION
Helmet hook will not prevent helmet theft. See your Buell
dealer for helmet locking solutions.
See
Figure 2-136. Tw o metal hooks, cables and locktabs on
the tail section serve as helmet holders. To store helmet,
place cable through helmet D-ring. Place D-ring on helmet
hook and route cable loop under locktabs. Install and lock
seat to store helmet while motorcycle is stationary.
Figure 2-135. Seat Lock
Figure 2-136. Helmet Hook
Seat Lock
6995
b0591box
Helmet Hook (2)
Cable (2)
Lock Tabs (4)
D-Ring