3-4 2002 Buell X1: Engine
HOME
TORQUE VALUES
ITEM TORQUE NOTES
Anti-Rotation Screws (Lifter) 55-65 in-lbs 6-7 Nm page 3-42
Crankcase 3/8 in. Screws 22-27 ft-lbs 30-37 Nm page 3-61
Crankcase 5/16 in. Screws 15-19 ft-lbs 20-26 Nm page 3-61
Cylinder Head Screws
7-9 ft-lbs then
13-15 ft-lbs
then loosen
and repeat
torque
sequence
10-12 Nm then
18-20 Nm then
loosen and repeat
torque sequence
special pattern to tighten and 3 step tighten-
ing procedure, page 3-21
Cylinder Studs 10-20 ft-lbs 14-27 Nm special method to tighten, page 3-61
Front Isolator Mount Bolts 60 ft-lbs 81 Nm
LOCTITE THREADLOCKER 271 (red)
engine oil on washers and under bolt heads,
loosen one full turn and retighten to 60 ft-
lbs, special procedure, page 3-20
Gearcase Cover Screws 80-110 in-lbs 9-12 Nm special pattern to tighten, page 3-49
Isolator Bolt, Front 100-110 ft-lbs 136-149 Nm page 3-10
Isolator TORX Bolts, Rear 63-70 ft-lbs 85-95 Nm
LOCTITE THREADLOCKER 262 (red) and
ANTI-SEIZE under bolt heads, special pro-
cedure, page 3-10
Oil Filter Adapter 8-12 ft-lbs 11-16 Nm
LOCTITE THREADLOCKER 243 (blue) to
mount side only, page 3-40
Oil Pressure Indicator Switch 50-70 in-lbs 6-8 Nm page 3-40
Oil Pump Cover TORX Screws 70-80 in-lbs 8-9 Nm page 3-39
Oil Pump Mounting Screws 125-150 in-lbs 14-17 Nm page 3-39
Pinion Shaft Nut 35-45 ft-lbs 48-61 Nm
LOCTITE THREADLOCKER 262 (red),
page 3-48
Push Rod Cover Retainer Screw 15-18 ft-lbs 20-24 Nm page 3-42
Rocker Box Bolts 10-14 ft-lbs 14-19 Nm page 3-22
Rocker Box Cover Screws 10-14 ft-lbs 14-19 Nm page 3-22
Rocker Box Screws 135-155 in-lbs 15-18 Nm page 3-22
Rocker Box to Head Bolts 18-22 ft-lbs 24-30 Nm tighten in cross pattern, page 3-22
Swingarm Mount Block Bolts, Lower 68-75 ft-lbs 92-102 Nm page 3-10
Swingarm Mount Block Bolts, Upper 41-45 ft-lbs 56-61 Nm page 3-10
Tie Bar Bolts 30-33 ft-lbs 41-45 Nm page 3-10
To Next Page