Buell X1 2002 - Page 256

4-38 2002 Buell X1: Fuel System
HOME
Test 4.14 (Part 1 of 2)
Run fuel pressure test as described under
4.14 FUEL PRESSURE TEST. Fuel pres-
sure should remain steady at 46-53 PSI
(317-365 kPa). Does it?
Flush out fuel cell
and clean inlet
screen. See
4.37
FUEL TANK
.
YES
No trouble
found. Review
symptoms.
YES
Check for faulty fuel
pump and replace.
See
4.40 FUEL PUMP.
NO
Check for faulty fuel
pump and replace.
See
4.40 FUEL
PUMP
.
Low pressure. High pressure.
7455
7461
7459
Check voltage drop between
battery positive (+) and Termi-
nal D (-) on pump side of con-
nector [89] during first two
seconds after key ON. Is volt-
age greater than 1 VDC?
Check for restricted
pump inlet screen. Is
screen restricted?
NO
Move negative (-) probe to GY
wire on Terminal 87 of ignition
relay. Measure voltage during
first two seconds after key ON.
Is voltage greater than 1 VDC?
YES
Locate and repair poor
connection between ignition
relay and fuel pump.
NO
Move negative (-) probe to
GY/O wire on Terminal 30 of
ignition relay. Measure voltage
during first two seconds after
key ON. Is voltage greater
than 1 VDC?
YES
Locate and repair poor
connection between bat-
tery and ignition relay.
NO
Replace ignition relay.
See Section 7.
YES
7457
7458
7456
Go to Test 4.14
(Part 2 of 2)
.
STOP
No pressure.