Buell X1 2002 - Page 299

2002 Buell X1: Fuel System 4-81
HOME
Code 44 Test (Part 1 of 2)
Is bank angle
sensor connected?
YES
Disconnect bank angle sensor
connector [134]. Measure voltage on [134]
between Socket A (Lt GY/GN) and
Socket B (BK). What is voltage?
NO
Reconnect. Clear
codes and cycle
ignition key.
Recheck for codes.
Repair short to
voltage on
Lt GY/GN wire.
4.0-6.0 volts
Measure voltage between Socket C (GY)
and Socket B (BK). Is voltage 11-13 volts?
11-13 volts 0 volts
Go to Code 44 Test
(Part 2 of 2).
YES
Is bank
angle sensor
correctly installed?
NO
Repair open in
GY wire between
[134] and
harness.
YES
Are ferrous metals located within
0.25 in. (6.4 mm) of sides, face or
top of bank angle sensor?
NO
Install properly. See 4.34 BANK
ANGLE SENSOR
.
YES
Return to original
configuration.
NO
STOP
Replace bank angle sensor. See 4.34
BANK ANGLE SENSOR
.
1
7971
7972
7975
7976