Buell X1 2002 - Page 95

2002 Buell X1: Chassis 2-27
HOME
4. See Figure 2-37. Tighten clamp screw on lower triple
clamp to 30-35 in-lbs (3-4 Nm).
5. See
Figure 2-36. Tighten master cylinder banjo bolt (1)
(metric) to 16-20 ft-lbs (22-27 Nm).
6. Tighten brake caliper banjo bolt (6) (metric) to 16-20 ft-
lbs (22-27 Nm).
11WARNING1WARNING
Always test motorcycle brakes at low speed after servic-
ing or bleeding system. To prevent death or serious
injury, Buell recommends that all brake repairs be per-
formed by a Buell dealer or other qualified mechanic.
7. Install bleeder valve if removed. Refill master cylinder
and bleed brakes. See
1.7 BRAKES.
11WARNING1WARNING
Check for proper brake lamp operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper brake lamp operation could
result in death or serious injury.
8. Turn ignition key switch to IGN. Apply brake hand lever to
test brake lamp operation. Turn ignition key switch to
LOCK.
Figure 2-37. Lower Triple Clamp
7048