Burkert 8691 - 3 BASIC SAFETY INSTRUCTIONS

10
Basic safety instructions
3 BASIC SAFETY INSTRUCTIONS
These safety instructions do not consider any contingencies or incidents which occur during installation,
operation and maintenance.
Theoperatorisresponsibleforobservingthelocation-specicsafetyregulations,alsowithreferencetothe
personnel.
DANGER
Riskofinjuryfromhighpressureanddischargeofmedium.
▶ Beforeworkingonthedeviceorsystem,switchothepressure.Ventordrainlines.
DANGER
Riskofinjuryfromelectricshock.
▶ Beforeworkingonthedeviceorsystem,switchothepowersupply.Secureagainstreactivation.
▶ Observe applicable accident prevention and safety regulations for electrical equipment.
Topreventinjury,ensurethefollowing:
▶ Secure device or system to prevent unintentional activation.
▶ Only trained technicians may perform installation and maintenance work.
▶ Perform installation and maintenance with suitable tools only.
▶ Do not make any changes to the device and do not subject it to mechanical stress.
▶ Operate the device only in perfect state and in consideration of the operating instructions.
▶ Observe the general rules of technology.
▶ Install the device according to the regulations applicable in the respective country.
▶ Donotfeedcorrosiveorammablemediaintothedeviceconnections.
▶ Donotfeedanyuidsintotheconnectionsofthedevice.
▶ After the process is interrupted, restart in a controlled manner. Observe sequence:
1. Connect electrical or pneumatic power supply.
2. Charge the device with medium.
▶ Observe intended use.
Thedevicehasbeendevelopedwithdueconsiderationgiventotheacceptedsafetyrulesandis
state-of-the-art.Nevertheless,dangeroussituationsmayoccur.
english
Type 8691, Rev. 2