BVL V-MIX Fix Plus - Page 60

Transport, setup, and initial commissioning
60
Translation of the Original Operating Manual
V-MIX Fix Plus
1. Using lifting equipment, carefully position the ma-
chine in the intended location.
2. Align the machine such that the container is level.
2.1 Loosen the clamping screws (2) at the feet of
the machine.
2.1 Adjust the height level of the machine using
the height adjusting screws (1).
2.1 Re-tighten the clamping screws (2) firmly.
3. Drill holes through the base plates (3) into the foun-
dation.
4. Fasten the machine in place with suitable fasteners,
e.g. heavy-duty anchors.
Fig. 5-2
Fig. 5-3
3
2
1