C-Data FD1216S - Speed; Flow-Control

Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
28
【Command】
duplexport‐listduplex
【View】viewge;Viewxge;
【Parameter】
port‐list：To‐be‐checkedportlist.
duplex：duplexmodeofEthernet，Value：half、full。
【Description】
ThiscommandisusedtoconfiguretheEthernetportduplexmode.Aftersuccessfulconfiguration,
theEthernetportwillbe
setatfullduplexorhalfduplexmode.
【jExample】
OLT(interface‐ge)#duplex1full

7.8speed
【Command】
speedport‐listspeed
【View】Viewge.
【Parameter】
port‐list
： To‐be‐checkedportlist.
speed：thespeedofEthernetport;Value：10,100,1000
【Description】
ThiscommandisusedtosettheEthernetportspeed,portworksatsetrate.
【Example】
Ge1portspeedissetas100Mbit/s.
OLT(interface‐ge)#speed1100

7.9flow‐control
【Command】
flow‐controlport‐list
noflow‐controlport‐list
【View】 geviewsEPONviews;xgeviews;link‐aggregationviews.
【Parameter】
port‐list
： To‐be‐checkedportlist.
【Description】
Opening ports for flow control function, The command “no”is used to close the port flow
controlfunction.
【Example】
OLT(interface‐EPON)#flow‐control1
