Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
53
【View】viewge;viewEPON;viewxge;viewlink‐aggregation.
【Parameter】
port‐id：To‐be‐setportlist.
mode
：
point‐to‐pointmodeofspanning‐tree.，value：true,false,auto
【Description】
Spanning‐tree point‐to‐point command is used to set the currentEthernet port which is link of
point‐to‐point. . When need to control the switch time of Ethernet status,you need to
configure whether thelink is a
point‐to‐point link, using this command. Setting the currentlink
connected as the Ethernet port of point‐to‐point links, command the Ethernet ports send fast
migrationrequest,iftheEthernetportmeetthepoint‐to‐pointlink,youcanmovequickly.
【Example】
Settingthepoint‐to‐point
modeoffe1astrue.
OLT(interface‐ge)#spanning‐treepoint‐to‐point1true
10.10spanning‐treepriority
【Command】
spanning‐treepriorityport‐idpriority
【View】viewge;viewEPON;viewxge;viewlink‐aggregation.
【Parameter】
port‐id：To‐be‐setportlist.
priority
：
priorityofport.Thisvaluemustbea16‐step.Configuredvalueissmaller,thehigherthe
priorityoftheport.
【Description】
Spanning‐tree priority command is used to set the priority of the port in the spanning‐tree of
instance,Port priority is important gist which determine whether the port
is selected as a root
port. In the calculation process of spanning‐tree, the high priority ports will be selected as the
root port under the same conditions . Setting the priority of port in the specify spanning tree
instance,thedevicewouldselecttheportbasedonhigh
orlowpriority.
Thepriorityofportspanning‐treeis16.
OLT(interface‐ge)#spanning‐treepriority116
To Next Page
Loading...
General