Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
51
TheHellotimetimeparameterofdevicewasset ,equipmentbasedonsettimeintervals,send
Hellomessagetotheswitcharound.
【Example】
SettingthehellotimeofOLTas1s.
OLT(config)#spanning‐treetimerhello1
10.5spanning‐treetimermax‐age
【Command】
spanning‐treetimerma x‐agetime
【View】viewconfig
【Parameter】
time：timeparameterofmaxage，Themaximumageofamessagethreshold.
【Description】
Command is used to set the device's Max Age (maximum age of a message) time parameter.
Whenyouneedtodeterminewhether
theconfigurationmessageobsolete,usingthiscommand.
After you set the Max Age time parameters of the device, the device discard configuration
messageswhichexceedthesettingvalue.Range:6‐40second,thedefaultvalueis20seconds.
【Example】
SettingthemaxageofOLTas6s.
OLT(config)#spanning‐tree
timermax‐age6
10.6spanning‐treeedged‐port
【Command】
spanning‐treeedged‐portport‐idswitch
【View】viewge;viewEPON;viewxge;viewlink‐aggregation.
【Parameter】
port‐id：To‐be‐setportlist.
switch
：
Port as an edge port switches or not. Values: enable, and disable. Enable: set the
specified Ethernet port as edge port. Edge ports : not directly connected with any switch or
through a network port is indirectly connected with any switch port. Disable: set the specified
Ethernetportsfornon‐edge
ports.
【Description】
ThiscommandisusedtoconfiguretheEthernetportas anedgeportornot.Whenyouwantto
allowtheportquicklymigratetotheforwardingState,canalsoguaranteenetworksecuritywhen
usingthiscommand.Fordirectlyconnectedtotheterminalsoftheport,the
portshouldbesetto
theedgeport,startatthesametimeBPDU(BridgeProtocolDataUnit)protectionfunction.After
yousetthecurrentEthernetportastheedgeportdevice,itwillnotreceiveanymessageswhich
comesfromotherbridgedevice.
【Example】
To Next Page
Loading...