Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
34
AddingastaticMACaddresstoOLTge1port,thecorrespondingVLANis100.
OLT(config)#mac‐addressstaticportge1vlan100e0:67:b3:00:12:9c
7.19mac‐addresstimer
【Command】
mac‐addresstimeraging‐time
mac‐addresstimerno‐aging
【View】Viewconfig
【Parameter】
aging‐time
:
MACaddressagingtime.
no‐aging:setstheMACaddressasnotaging.usingthisparameterwhenyoudonotneedtoopen
theMACaddressaging
【Description】
This command is used to set theaging time of dynamic entries in MAC dynamic address table .
After MAC address aging
time setting successfully,it tak es effect immediately,and the system
regularlycheckthedynamicMACaddress,ifinagingperiods(1–twicetimestheagingtime),the
system does not send or receive any message that carries the source MAC address, the
corresponding MAC address is removed from the MAC address table.
Dynamic MAC address
agingregularrelease the MACaddressresource,whichavoidthesystemcannotlearnnewMAC
addresses.
【Example 】
TheMACaddressagingtimeissetto60seconds
OLT(config)#mac‐addresstimer60
7.20mac‐addresslearning
【Command】
mac‐addresslearningportgeport‐listswitch
mac‐addresslearningportEPONport‐listswitch
mac‐addresslearningportxgeport‐listswitch
【View】Viewconfig
【Parameter】
port‐list
:
To‐be‐checkedportlist.
switch
:
MACaddresslearningfunctionswitch,value:enable、disable。
【Description】
Thiscommandis used to enableordisableONTMACaddresslearning function. Whenitcomes
tothesceneofagreatnumberlearningMACaddress(suchasadedicateduser)andsoon,can
beconfiguredasdisable.