C-Data FD1216S - Traffic-Outervlan; Traffic-Priority

Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
62
OLT(config)# traffic-mirror inbound 2000 port ge 1 to ge 2
12.5 traffic‐outervlan
【Command】
traffic‐outervlaninboundacl‐id[rule‐idrule‐id]port（ge|EPON|xge）port‐listvlanvlanID
notraffic‐outervlaninboundacl‐id[rule‐idrule‐id]port （ge|EPON|xge）port‐list
【View】
Configview
【Parameter】
Inbound:thetrafficoninbound
packetsoftheinterface
Outbound： thetrafficonoutboundpacketsoftheinterface
rule‐id： theruleIDofACL
acl‐id:ACL’sname
port‐list：portslist
vlanID:
Add the outer label 
【Description】
traffic‐outervlan:
This command is used to configure an ACL outer vlan for the specified port, and make
it into effect. When you need to use the ACL rules to add outer vlan for port, you can use this command.
notraffic‐outervlan: Command is used to cancel the addition of ACL outer vlan for the specified
port. When you need to delete the addition of ACL outer vlan for the specified port, you can use
this command.
【Example】
Intheworktimeperiod,addoutervlan10tomessagethatisfromport1anditsipis10.10.10.2.
OLT(config)#time‐rangeworktime8:00to18:00working‐day
OLT(config)#acl2000
OLT(acl‐basic‐2000)#rule2permitsource10.10.10.20.0.0.0time‐rangeworking‐day

OLT(acl‐basic‐2000)#exit
OLT(config)# traffic-outervlan inbound 2000 port ge 1 vlan 10
12.6 traffic‐priority
【Command】
traffic‐priorityinbound acl‐id[ rule‐idrule‐id ]port （ ge | EPON | xge ） port‐list
remark‐prioritypri‐value
notraffic‐priorityinboundacl‐id[rule‐idrule‐id]port （ge|EPON|xge）port‐list
【View】
Configview
【Parameter】

