Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
88
【Command】
port eth ont‐portid ( [ds‐policing (traffic-table-index| unconcern)] | [group‐num‐maxnum]
|[ multicast‐tagstrip( tag | untag )] | [up‐policing(traffic-table-index| unconcern)] |
[max‐mac‐count(num|unlimited])
no
【View】 srvprofileview
【Parameter】
ont-portid：theportID
ofont
up-policing
traffic-table-index：
Traffic profile for downstream
The table of upward
flow on the ETH port
ds-policing
traffic-table-index：
Traffic profile for upstream
Unconcern：
Don't focus on flow control of ETH port
multicast-tagstrip： Configure the VLAN tag processing mode for,there are two processing
modes:
untag：
strip off VLAN Tag
of
multicast downstream data packets
tag： To passthrough multicast downstream data packets
max-mac-countnum
：
Set the maximum number of MAC addresses learned , When value reaches
ceiling, port is no longer to learn the new MAC address.
Unlimited： Unlimiting the maximum number of MAC addresses learned
Group-num-max num:
Set the maximum number of multicast group allowed.
【Description】
This command is used to set ONT business of the Ethernet ports in the template parameters,
including the flow control of the TDD Ethernet port, the learning maximum number of MAC
addresses, the processing methods of multicast message TAG data, the VLAN mode on ports, the
maximum number of multicast you allow properties, etc. When you need to modify the Ethernet
port parameters of the ONT business template, use this command.
【Example】
The indexof downward flowis 1on the ETH 1, the VLAN Tag way of the multicast data packets is the Tag,
the largest learning number of MAC address is 64, the maximum number of multicast program allows is
100.
OLT(config‐ont‐srvprofile‐10)# port eth 1 ds‐policing 1 multicast‐tagstrip tag max‐mac‐count 64
group‐num‐max100
17.5showont‐srvprofile
【Command】
showont‐srvprofile(all|profile‐idprofile‐id|profile‐nameprofile‐name)
【View】 configview
【Parameter】
all： ShowallONTserviceprofiles,includingprofileID,name,
number of bound and so on.
profile‐idprofile‐id： Show
detailed information of specific
ServiceprofileID 查询指定 IDEPONONT
业务模板的详细信息。
To Next Page
Loading...
General