To Next Page

To Previous Page

Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)

Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506

Website: www.cdatatec.com

【Command】

Llidllid‐list ([(dba‐profile‐id profile‐id | dba‐profile‐nameprofile‐name)] | [ encrypt ( off

|triple‐churning)]|[ont‐carProfile‐id ])

nollidllid‐list([dba‐profile]|[ont‐car])

【View】 configview

【Parameter】

profile‐id

：

 LinetemplatenumberofEPONONT,itis

used to identify uniquely a line template



profile‐name

：

 Line template name of EPON ONT, The default template name is“ line‐

profile_x”,"x"istheactualtemplatenumber.

Llid‐list: Logic Link ID

【Description】

Llid:ThiscommandisusedtosetupDBAmodel,flowcontroltemplateandencryptionswitch

of epon llid in the line template,when you need to config

 uplink bandwidth  , flow control,the

encryption parameters for a batch of ont by the ont‐line‐template,you can use this command .

Afterthecommandexecutesuccessfully,throughthecommit

commandtosubmitONTbusiness

templates,configurationparameterscanbeissuedtotheONTinbatch.

【Example】

Thedownwardflowisencryptedaboutdba‐profile‐1inont‐lineprofile‐10

OLT(config)#ont‐lineprofileprofile‐id10

OLT(config‐ont‐lineprofile‐10)#llid1dba‐profile‐id1encrypttriple‐churning

OLT(config‐ont‐lineprofile‐10)#commit



DeleteDBAtemplateandflowcontroltemplateofont‐lineprofile‐10

OLT(config‐ont‐lineprofile‐10)#nollid1dba‐profile

OLT(config‐ont‐lineprofile‐10)#nollid1ont‐car

16.3fec

【Command】

fec(enable | disable)

【View】 configview

【Parameter】

enable:enableFEC

disable:disableFEC

【Description】

This command is used to set the switch state of the line template ONT FEC (Forward Error

Correction), when you need to increase the reliability of data transmission that is between OLT

and ONT, you can use this command to modify the template parameters of FEC. after ONT FEC

function enable, the system inserted into the redundant data in the normal message, it make the

line has the function of the fault tolerance, but it will waste bandwidth resources.

【Example】

OpenthefunctionoftheFECin10linetemplate

OLT(config)#ont‐lineprofileprofile‐id10

OLT(config‐ont‐lineprofile‐10)#fecenable

Brand	C-Data
Model	FD1216S
Category	Switch
Language	English

C-Data FD1216S User Manual

Table of Contents

Questions and Answers:

C-Data FD1216S Specifications