EasyManuals Logo

C-Data FD1216S User Manual

C-Data FD1216S
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
61
remarkdscpvalue
To remark the DSCP value
ratevalue:
The rate of the interface
Describtion
trafficlimit:
Command is used to specify the discharge port configuration ACL, and make it into effect.
When you need to use the ACL rules for port rate limit, use this command.
no trafficlimit: This
ciommand is used to cancel the ACL traffic restrictions specified port. When you
need to delete the specified port of ACL speed limit function, use this command.
Example
In the worktime period, message from IP address is 10.10.10.2, message came in from interface 1,
the guarantee bandwidth is 1 M, the average bandwidth is 100 M, theexceeding flow discarded.
OLT(config)#timerangeworktime8:00to18:00workingday
OLT(config)#acl2000
OLT(aclbasic2000)#rule2permitsource10.10.10.20.0.0.0timerangeworkingday
OLT(aclbasic2000)#exit
OLT(config)#rafficlimitinbound2000portge1cir1024pir102400exceeddrop
12.4
trafficmirror
Command
trafficmirrorinboundaclid[ruleidruleid]portge|xgeportlisttoge|EPON|xge
portlist
notrafficmirrorinboundaclid[ruleidruleid]port ge|xgeportlist
View
Configview
Parameter
Inbound:the
trafficoninboundpacketsoftheinterface
Outbound thetrafficonoutboundpacketsoftheinterface
ruleid IDtheruleIDofACL
aclid:ACLsname
portlistportslist
Description
trafficmirror: This commond is used to configuration ACL traffic mirror for specify port, and
make it into effect. When you need to use the ACL rules on port traffic mirror,you can use this
command.
notrafficmirror: This command is used to cancel ACL traffic mirror of.the specified port , When
you need to delete the ACL traffic mirror function of the specified port ,you can use this
command.
Example
Intheworktimeperiod,thatmessage’
IPaddressis10.10.10.2fromtheport1,itmirroredtoport
2.
OLT(config)#timerangeworktime8:00to18:00workingday
OLT(config)#acl2000
OLT(aclbasic2000)#rule2permitsource10.10.10.20.0.0.0timerangeworkingday
OLT(aclbasic2000)#exit

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the C-Data FD1216S and is the answer not in the manual?

C-Data FD1216S Specifications

General IconGeneral
BrandC-Data
ModelFD1216S
CategorySwitch
LanguageEnglish