Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
67
Systems support PQ, WRR, WRR + PQ scheduling model. When a queue is empty,system can
switch immediately to the next queue scheduling,it make full use of bandwidth resource.
o
When existing WRR queue scheduling, the sum of weights must be 100
o The
WRR + PQ scheduling mode is a mixture of WRR and PQ two scheduling model.
When there is a zero value in the weight of the queue, queue scheduling model is the
PQ + WRR scheduling model. In this mode, the system schedule queue that weight is
0in PQ model, then scheduling queue that weights isn’t 0 in the WRR mode, and the
priority of PQ queue is higher than the WRR queue.
o
When Configure WRR + PQ way queue scheduling, the queue of PQ mode
scheduling must be configured in the priority queue, do not allow the PQ queue
alternating configure.with WRR queue
o
The default scheduling of system is PQ scheduling
【Example】
Example: configure the queue scheduling model is WRR, making all kinds of priority message
can be scheduled. The weight of the queue 0-3 is 10,30,30,30 respectively
OLT(config)# qos queue-scheduler wrr 10 30 30 30
12.12
showqueue‐scheduler
【Command】
showqueue‐scheduler
【View】
Configview
【Parameter】
nothing
【Description】
This command is used to query system currently used queue scheduling mode.
【Example】
In the worktime period, viewing all the QOS strategy about port 1.
OLT(config)#showqueue‐scheduler
Queueschedulermode:WRR
QueueSchedulerModeWRRWeight
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
0WRR10
1WRR30
2WRR30
3WRR30
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
Queuemap:
To Next Page
Loading...