Canon imageCLASS LBP121dn - Page 112

The port name is entered automatically, so change it, as needed.
When [Additional port information r
equired] Appears
Take action following the instructions on the screen. To set [Device Type], select [Canon Network Printing
Device with P9100] in [Standard].
6
Click [Finish].
➠ A ne
w port is added, and the [Printer Ports] screen is displayed.
7
Click [Close]
[Close].
Changing the Port Type and Number
If the machine is congured not to use LPD or RAW, you must change the type of port on the computer to a protocol
usable on the machine.
If the LPD or RAW port number was changed, the settings on the computer may have to be changed to match the
settings on the machine.
* You do not need to change the port type or number on the computer for WSD ports.
Administrator privileges are required on each computer.
1
Log on to the computer using an administrator account.
2
Click [ ] (Start) [ ] (Settings) [Devices] [Printers & scanners].
➠ The [Printers & scanners] scr
een is displayed.
3
Click the printer driver of the machine
[Manage] [Printer properties].
➠ The printer driver pr
operties screen is displayed.
4
On the [Ports] tab, click [Congur
e Port].
➠ The [Congure Port] screen or [Congure Standard TCP/IP Port Monitor] screen is displayed.
Printing
105