Canon imageCLASS LBP121dn - Reducing Power Consumption (Sleep Mode)

Reducing Power Consumption (Sleep Mode)
95LW-01X
Sleep mode r
educes power consumption by pausing certain operations inside the machine.
You cannot manually put the machine into sleep mode. If no operations are performed for a certain period of time, the
machine automatically enters sleep mode.
The display turns off in sleep mode.
◼ Exiting Sleep Mode
Press any key on the operation panel to exit sleep mode.
◼ Conguring Auto Sleep Time
Auto Sleep is a function that automatically places the machine into sleep mode if no oper
ations are performed for a
certain period of time. You can specify the timing of Auto Sleep.
This section describes how to congure the settings using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then select [Preferences] to congure the settings.
[Timer/Energy Settings](P. 201)
1
Log in to Remote UI.
Starting Remote UI(P. 179)
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of
Remote UI(P. 181)
3
Click [Timer Settings] [Edit].
➠ The [Edit Timer Settings] scr
een is displayed.
4
Enter the time in [Auto Sleep Time].
* It is recommended to use the default setting to eciently save po
wer.
[Auto Sleep Time](P. 202)
5
Click [OK].
➠ The settings ar
e applied.
6
Log out from Remote UI.
● The machine does not enter sleep mode in the follo
wing cases:
- When the data indicator on the operation panel is lit or blinking
Operation Panel(P. 10)
-
When the [Menu] screen, a paper jam or other error message
*1
, or Direct Connection SSID or network key
display screen is displayed on the operation panel
Basic Operations
76