Connecting to a Wireless LAN by Using the Router
Button (Push Button Mode)
95LW-012
If your wir
eless LAN router supports WPS push button mode, you can easily set up a connection simply by using the
operation panel of the machine and the button on the wireless LAN router.
Administrator privileges are required to connect to a wireless LAN.
1
On the operation panel, select [Menu] in the [Home] screen and press
. [Home]
Scr
een(P. 81)
2
Press [Preferences
[Network] [Wireless LAN Settings] .
➠ The [Select Network] screen is displayed.
● If the login screen appears, enter the System Manager ID and PIN, and then press . System Manager
ID and PIN(P
. 4)
● If the message [Enable the wireless LAN?] appears, select [Yes] and press
.
● If the message [Cannot nd the access point.] appears, pr
ess
.
3
Select [Other Connections] and press .
4
Select [WPS Push Button Mode] and press .
➠ The machine starts sear
ching for an access point.
5
After the search for an access point starts, press the button on the wireless LAN
r
outer within two minutes.
Press the button within two minutes. (Depending on the wireless LAN router, you may have to press and hold
the button.)
* For details on ho
w to operate the button, see the manual of your wireless LAN router.
6
When [Connected.] appears on the operation panel, press
.
➠ When the machine is connected to the wir
eless LAN, [
] appears on the [Home] screen.
7
Wait a few minutes.
➠ By default, an IP addr
ess is set automatically.
To use a specific IP address, set this manually.
Setting IPv4 Addresses(P. 50)
Setting IPv6 Addresses(P. 52)
Setting Up
41
To Next Page
Loading...
