Canon imageCLASS LBP121dn - Page 231

[On]
[Talc Paper Mode]
[Menu] [Adjustment/Maintenance] [Adjust Image Quality] [Special Processing]
When you use very dusty paper, the printed image may be faded, or str
eaks may appear in the image. In this case,
selecting [On] may improve the print results.
*When you select [On], the print quality may be affected.
[Off]
[On]
[Correct Blurry Image]
[Menu] [Adjustment/Maintenance] [Adjust Image Quality] [Special Processing]
Smudges may appear on the printed paper. In this case, selecting [Mode 1] may impr
ove the print results. If that does
not work, try selecting [Mode 2].
[Off]
[Mode 1]
[Mode 2]
[Transfer Adjustment Mode]
[Menu] [Adjustment/Maintenance] [Adjust Image Quality] [Special Processing]
Depending on the paper used, printing may appear une
ven with printing in a humid environment. In this case,
selecting [Mode 1] may improve the print results. If that does not work, try selecting [Mode 2].
* When this setting is enabled, the print density may vary in an environment with low humidity.
[Off]
[Mode 1]
[Mode 2]
[Reduce Faint Print After Replacing Cart.]
[Menu] [Adjustment/Maintenance] [Adjust Image Quality] [Special Processing]
Print may be faded immediately after installing a ne
w replacement toner cartridge. If so, specifying [On] in this setting
may improve the print results. This setting takes effect the next time a toner cartridge is replaced.
* Specifying [On] will result in a longer delay than usual between replacing toner cartridge and being able to print.
[Off]
[On]
Settings Menu Items
224