•
When the Media Take-up Unit is used, or when the Output Stacker is stored for long periods
Lower it to position (3) for storage. (See "Stowing the Stationary Output Stacker.") →P.661
When
using the Output Stacker again after storage, reattach the Basket Rod on the front of the Output Stacker to the
tips of the left and right basket arms and pull the side rods out completely.
•
When printing on large, stiff sheets
Use position (3).
Important
• When
storing printed documents on the Output Stacker, always use it in position (1). If you do not, printed
documents may not be dropped into the Output Stacker, and the printed surface may become soiled.
• The Output Stacker can accommodate one sheet. When printing multiple pages, remove each sheet after it is
printed.
• Before using the Output Stacker, remove the Rewind Spool. If you do not, it may prevent printed documents
from being held correctly, and they may be scratched.
• The Output Stacker can hold printed documents from rolls that are 62 inches (1,575 mm) long. When print-
ing longer documents, use the optional Media Take-up Unit.
The Output Stacker locks into position if you lift it to position (1) or (2). To lower the Output Stacker, lift the front Basket
Rod lightly to release the lock, and then lower the stacker.
Handling Paper
>
Output Stacker
>
Using the Stationary Output Stacker iPF815
7
660
To Next Page
Loading...
Need help?
General
Weight and Dimensions
