Canon imagePROGRAF iPF815 - Using the Stationary Output Stacker

e.
Basket Rod
Keeps Basket Arm R and Basket Arm L at the same angle.
f.
Rear Holder
Holds the middle of the Basket Rod (cord side).
(See "Using the Stationary Output Stacker.") →P.659
Note
• The
printer can be used with either a Stationary Output Stacker or a separate, mobile Wheeled Output Stack-
er.
The Stationary Output Stacker is normally provided as the standard stacker, but the Wheeled Output Stacker
may be the standard stacker in some sales regions. If the Wheeled Output Stacker has been provided as the
standard stacker, the Stationary Output Stacker is not included.
For more information about the Wheeled Output Stacker, see "Wheeled Output Stacker."
→P.663
Using the Stationary Output Stacker
The Stationary Output Stacker can be used in three positions, as shown.
•
When storing printed documents on the Output Stacker
Use position (1).
•
When the Output Stacker is not used
Move the stacker into position (2).
Handling Paper
> Output Stacker >
iPF815 Using the Stationary Output Stacker
7
659