Canon imagePROGRAF iPF815 - HP-GL2 Jobs Are Printed 6 MM Larger than Specified; HP-GL2 Jobs Are Printed at Maximum Size, Even if a Standard Size Is Specified; HP-GL2 Printing Takes a Long Time; The Printer Stops When Printing a HP-GL2 Job (the Carriage Stops Moving)

HP-GL/2 jobs are printed 6 mm larger than specified
Cause Corrective Action
The page size of the HP-GL/2 print job, as created in the source ap-
plication, is incorrect.
In MAIN MENU, set PageSizeProcess1 to On.
(See "Main Menu Settings.") →P.722
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
Cause Corrective Action
The page size of the HP-GL/2 print job, as cre-
ated in the source application, is incorrect.
In MAIN MENU, set PageSizeProcess2 or Conserve Paper to On.
The layout will be changed to the optimal layout.
(See "Main Menu Settings.")
→P.722
HP-GL/2 printing takes a long time.
Cause Corrective Action
Large print jobs with a lot of data take longer to print. On the printer Control Panel, set Input Resolution to 300dpi.
(See "Main Menu Settings.") →P.722
The printer stops when printing a HP-GL/2 job (the carriage stops moving)
Cause Corrective Action
The printer is analyzing the
print job.
Either wait a while for printing to resume, or on the printer Control Panel, set Input
Resolution to 300dpi.
(See "Main Menu Settings.") →P.722
Troubleshooting
> HP-GL/2 problems >
iPF815 HP-GL/2 jobs are printed 6 mm larger than specified
12
883