Canon TX-3000 - Default Network Settings

Default Network Settings
LAN Connection Defaults
Item Default
Change LAN Activate wired LAN
SSID BJNPSETUP
Communication mode Infrastructure
Wireless LAN security Disable
IP address (IPv4) Auto setup
IP address (IPv6) Auto setup
Set printer name* XXXXXXXXXXXX
Enable/disable IPv6 Enable
Enable/disable WSD Disable
Timeout setting 15 minutes
Enable/disable Bonjour Enable
Service name Canon TX-3000
LPR protocol setting Enable
Wireless LAN DRX setting Enable
Wired LAN DRX setting Enable
("XX" represents alphanumeric characters.)
* Default value depends on printer. To check value, use operation panel.
LAN settings
Wireless Direct Defaults
Item Default
SSID (Identifier for wireless direct) DIRECT-abXX-TX-3000 *1
Password YYYYYYYYYY *2
Wireless LAN security WPA2-PSK (AES)
Wireless Direct device name ZZZZZZ-TX-3000 *3
Connection request confirmation Displayed
*1 "ab" is specified at random and "XX" represents last two digits of printer's wireless MAC address.
331